[BC] Schematics needed

[Rich harkoff]

Hi Phil,
You are correct, 9 pin, TYPO, my bad. Thank's very much for the info, I was
about to take the output assembly apart and start tracing the circuit.
I appreciate your time on this.
Thanks again,
Rich Harkoff


----- Original Message ----- 
From: "Phil Langston" <langston at adams.net>
To: "Broadcast Radio Mailing List" <broadcast at radiolists.net>
Sent: Saturday, July 16, 2005 1:13 PM
Subject: Re: [BC] Schematics needed


> Rick,
>
> If this is the Mono 4 channel board TS-2 is a 9 position strip:
>
> 1. Balanced Audio Out-Positive
> 2.Balanced Audio Out-Negative
> 3. Ground
> 4.Ground
> 5. Monitor out-from monitor select switch.
> 6 & 7 N.O. Contacts
> 8. Ground
> 9..External Cue Speaker Out
>
>
> Phil Langston
> BE RF Customer Service
>
>
> ----- Original Message -----
> From: "Rich harkoff" <rharkoff at new.rr.com>
> To: <broadcast at radiolists.net>
> Sent: Friday, July 15, 2005 12:58 PM
> Subject: [BC] Schematics needed
>
>
> Hi All,
> I'm in need of the pinouts for the output section of a BE four pot board
> model 901-0450-000. Terminal Strip 2 has 8 screws and I need pinouts for
> these.  Inputs are NOT needed. If anyone can help it would be much
> appreciated.
> Thanks,
> Rich Harkoff
> Green bay
>
> _______________________________________________
> This is the BROADCAST mailing list
> To send to the list, email: broadcast at radiolists.net
> For sub changes, archives and info on this other lists:
> http://www.radiolists.net/
>
>
> _______________________________________________
> This is the BROADCAST mailing list
> To send to the list, email: broadcast at radiolists.net
> For sub changes, archives and info on this other lists:
http://www.radiolists.net/
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Anti-Virus.
> Version: 7.0.323 / Virus Database: 267.8.16/50 - Release Date: 7/15/2005
>
>