[BC] New racks.

[Mike McCarthy]

Chris,

Sorry about the tpyo.

Call Mike at Cabtron.  They have a couple different rails for different 
cabinets with differing lateral dimensions for those cabinets. He can send 
you small pieces if necessary to test. Your best bet is to get a micrometer 
out and sketch the rail you have and send that data to Mike. One thing is 
they use round holes as a standard.  But the clips still go on them.  Ask 
him if they can stamp square holes if you need them.

Another option is AMCO in Franklin Park, IL.  They supply the cabinets to 
BE (and Nautel before they started their own metal shop) as well as a few 
others.  They offer rails which are also smaller in angle size as well. 
Anixter is their distributor.

MM

At 09:22 PM 2/15/2009 -0600, Chris Gebhardt wrote
>Mike McCarthy wrote:
>>That said, if Dave at VERIBITZ is swapping them out, I think that's going 
>>to be your best deal bar none.
>
>Uh, it's VIRTBIZ, but I wouldn't be such a shameless self promoter if I 
>didn't point that out.  ;)
>
>The trick will be to find the right measurement since I need them to fit a 
>specific application.   They need to have only a very narrow piece of 
>material between the holes and the point at which they mount to the inside 
>of the cabinet.  Being off just a little bit will make them pretty 
>worthless, since 19" = 19", not 18-7/8".
>
>Worst case, if we cannot salvage these cabinets and convert them then 
>we'll have some actually pretty darned nice cabinets for sale.  <shrug>.
>
>Chris Gebhardt
>VIRTBIZ Internet Services
>chris at virtbiz.com | (972) 485-4125