[BC] Right Angle XLR

[Bowen, Jonathan]

Well I went down to my supply closet and grabbed a brand new connector and played with it a bit. It's a neutrik NC3MRC. It is designed to put the cable out the side of pin 1. However it will work the other way. You can just screw it together the opposite way. It will basically work in any direction but it clips together nicer with the bend towards pin 1. once you screw it together it will not move. Hope that help

Jonathan Bowen
WPCS/RBN Field Engineer

-----Original Message-----
 [mailto:broadcast-bounces at radiolists.net] From: Mark Croom

Seems to me I was able to put a Neutrik together the way it worked best for
my particular application (microphone end connector). There was more than
one way to "skin the cat" as I recall, tho it's been a while since I did one
of these.

Mark
MN

On Sun, Feb 22, 2009 at 2:55 PM, Tom Dimeo <mwam at pa321.net> wrote:

> I don't know how to word this so it doesn't sound stupid but
> here goes.
>
> Which way does a right angle XLR connector go?  Does the
> angle turn away from one of the pins or from between two of
> the pins?
>

~____________________________________________________________________~
The BROADCAST [BC] list is sponsored by www.SystemsStore.com
Your Premium Supplier Of Components To Build and Maintain A Technical Infrastructure
www.SystemsStore.com          Tel: 407-656-3719          Sales at SystemsStore.com