[BC] IP STL

[Robert Meuser]

I got the impression this was on the REALLY cheap.

Me I would use a point to point T1 AND a digital STL AND spread spectrum backup. 
  But that DOES cost more.

R

Chris Gebhardt wrote:
> Robert Meuser wrote:
> 
>> I have had good experiences with the audio TX communicator. $700 per 
>> end for software that will run on a pretty modest computer, like a 600 
>> mhz pentium. I has the ability to operate with linear as well as mpeg 
>> audio. The software adjusts its buffering automatically based on 
>> network condition and can also function via ISDN.
>>
>> We even ran it off a laptop in the middle of Manhattan via plain 
>> vanella WIFI and it worked quite well.
>>
>> If you could get DSL lines with enough uplink speed, you could run 
>> linear audio and the network traffic would not likely be an issue if 
>> both DSL were from the same telco provider.
> 
> 
> DSL might work out well, but for a critical application like STL, I 
> would suggest T1 due to its more bullet-proof nature, wide availablity, 
> guaranteed transfer rates and superior SLA to protect you.
> 
> Since we (as well as other providers) are able to sell T1 for under 
> $300/month depending on location, it's really not that expensive a 
> venture.  Esp. not for the benefits.
> 
> Chris Gebhardt
> VIRTBIZ Internet Services
> chris at virtbiz.com | (866) 4-VIRTBIZ
> 
> _______________________________________________
> This is the BROADCAST mailing list
> To send to the list, email: broadcast at radiolists.net
> For sub changes, archives and info on this other lists: 
> http://www.radiolists.net/
>